Monday, November 19, 2012

LPC2106FHN48 mcu crack

LPC2106FHN48 mcu crack,NXP ARM decryption, ARM code extraction.
Single-chip 32-bit microcontrollers; 128 kB ISP/IAP flash with 16/32/64 kB RAM.
16/32-bit ARM7TDMI-S processor.
16/32/64 kB on-chip static RAM.
128 kB on-chip flash program memory. 128-bit-wide interface/accelerator enables high speed 60 MHz operation.
In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software. Flash programming takes 1 ms per 512 B line. Single sector or full chip erase takes 400 ms.
Vectored Interrupt Controller with configurable priorities and vector addresses.
EmbeddedICE-RT interface enables breakpoints and watch points. Interrupt service routines can continue to execute whilst the foreground task is debugged with the on-chip RealMonitor software.
Embedded Trace Macrocell enables non-intrusive high speed real-time tracing of instruction execution.
Multiple serial interfaces including two UARTs (16C550), Fast I2C-bus (400 kbit/s), and SPI.
Two 32-bit timers (7 capture/compare channels), PWM unit (6 outputs), Real Time Clock and Watchdog.
Up to thirty-two 5 V tolerant general purpose I/O pins in a tiny LQFP48 (7 mm x 7 mm) package.
60 MHz maximum CPU clock available from programmable on-chip Phase-Locked Loop with settling time of 100 us.
The on-chip crystal oscillator should have an operating range of 1 MHz to 25 MHz.
Two low power modes, Idle and Power-down.
Processor wake-up from Power-down mode via external interrupt.
Individual enable/disable of peripheral functions for power optimization.
Dual power supply:
CPU operating voltage range of 1.65 V to 1.95 V (1.8 V +- 8.3 pct).
I/O power supply range of 3.0 V to 3.6 V (3.3 V +- 10 pct) with 5 V tolerant I/O pads.

No comments:

Post a Comment